HP-UX 11i September 2003 Release Notes

HP-UX 11i Version 1.0 Operating Environment Applications
Selectable Applications
Chapter 6
153
Pay Per Use
Pay Per Use (PPU) provides cost savings by charging only for the percent utilization of
the processors in HP enterprise servers Superdome, rp7410, and rp8400. As computing
demands vary, the customer is charged according to the processor usage.
updated for
September 2003
The PPU version B.06.02 software is new for September 2003. There is no functional
change to the software from version B.06.00. There are only enhancements to improve
the software's operation.
new for June 2003 PPU version B.06.00 for June 2003 is a selectable product available on the 11i Operating
Environment and Application Release media.
Documentation
For information on current PPU documentation, see “On Demand Solutions” on
page 204.
The Pay Per Use B.06.00 manpages are as follows:
• ppu (5)
• ppud (1M)
• ppuconfig (1M)
Selectable Network Drivers
The following table indicates which drivers are selectable during HP-UX 11i installation.
updated for
September 2003
RAID-01 added as a selectable driver for the HP A7143A PCI 4-Channel RAID160 SA
SCSI Controller. For further information, see “RAID160 SA Controller Driver
(RAID-01)” on page 170.
updated for June
2002
The local and remote recovery features of EMS HA-ATM are now supported for HP-UX
workstations (7xx series).
TermIO drivers have been updated to repair defects.
updated for
September 2001
ATM drivers have been updated to repair defects and improve performance for PCI and
HSC.
TermIO drivers have updated to include 3.3Volt support and to repair defects for PCI
MUX and EISA MUX.
updated for June
2001
As of June 2001, several new I/O adapters are fully supported: A6684A, A6685A,
A6748A, A6749A, and A6386A.