HP-UX 11i September 2002 Release Notes

I/0 and Networking Cards
Network Drivers
Chapter 7
150
HP_BTLAN_INTERFACE_NAME[0]=
HP_BTLAN_STATION ADDRESS[0]=
HP_BTLAN_SPEED[0]=
#####################################################################
# The HP_BTLAN_INIT_ARGS are reserved by HP. they are NOT user changeable.
#####################################################################
HP_BTLAN_INIT_ARGS="HP_BTLAN_STATION ADDRESS HP_BTLAN_SPEED"
# End of hpbtlanconf configuration file
4. As described in steps a, b, and c below, merge every LAN interface (as shown to be
configured in Step 2) into the file hpbtlanconf in the
/var/adm/sw/save_custom/UNIFIED_MER directory.
a. First, note that a set of three parameters is required for each LAN interface:
• HP_BTLAN_INTERFACE_NAME,
• HP_BTLAN_STATION_ADDRESS and
• HP_BTLAN_SPEED.
b. Second, note that the index value used for the set of three parameters should be
unique for each interface. For example:
HP_BTLAN_INTERFACE_NAME[0]=lan1
HP_BTLAN_STATION_ADDRESS[0]=0x080009C4686E
HP_BTLAN_SPEED[0]=100HD
HP_BTLAN_INTERFACE_NAME[1]=lan2
HP_BTLAN_STATION_ADDRESS[1]=0x080009C4B23C
HP_BTLAN_SPEED[1]=FULL
c. Finally, merge all LAN interfaces by creating a set of three parameters with a
unique index for each:
• Copy the value of the interface name into the parameter
HP_BTLAN_INTERFACE_NAME.
• Copy the value of the station address into the parameter
HP_BTLAN_STATION_ADDRESS.
• If the SPEED parameter exists, and if its value (lowercase or uppercase) is
100FD or 100HD, 10FD or 10HD or auto_on, copy the value into the
HP_BTLAN_SPEED parameter.
However, if the SPEED parameter does not exist, and the DUPLEX parameter
has been set and its value (lowercase or uppercase) is FULL or HALF, copy
the value to HP_BTLAN_SPEED parameter.
If neither the SPEED nor DUPLEX parameter values have not been set, do not
put any value for the HP_BTLAN_SPEED parameter.
5. If the hpbtlanconf configuration file already exists (as
/etc/rc.config.d/hpbtlanconf), copy it to
/etc/rc.config.d/hplanconf.obsolete.
6. Move the file hpbtlanconf.merge to hpbtlanconf by using the command