HP-UX 11i Release Notes (December 2000)

Installation
Ignite-UX Changes (new)
Chapter 6 123
Ignite-UX Changes (new)
Ignite-UX Version B.3.0
Ignite-UX (IUX) Version B.3.0 is an HP-UX administration toolset to
help you install and configure or recover HP-UX systems.
The complete Ignite-UX product, with support for HP-UX 11i, 11.0 and
10.20, is available on the first CD of the 11i OE media kit.
NOTE Ignite-UX will not be installed by default when updating the entire
operating system from 10.20 or 11.00 to 11i even if the system currently
is an Ignite-UX server.
Updating your Ignite-UX server to 11i will ensure that you have the
latest version of make_recovery and can successfully run it on this
system. For details on updating an Ignite-UX server, see Chapter 3 of the
HP-UX 11i Installation and Update Guide.
If you are cold installing a system, you can select Ignite-UX from the
software selection screen to be installed at the same time the rest of the
OS is installed.
By default, running Ignite-UX will install the core HP-UX 11i files,
networking drivers, and the OE. You can deselect the OE but you cannot
install an OE subset using Ignite-UX. Also some of the networking
drivers are not deselectable.
Impact
Ignite-UX, Version B, no longer supports the installation of 10.01 and
10.10 machines for 11i. The B Version will continue to support 10.20 and
later operating system revisions. In addition, Version B will only operate
on HP-UX machinesthat have at least 64MBof RAM. Previously, HP-UX
machines that had at least 32MB of RAM were supported. Version A is
not affected by these changes.