HP-UX 11i March 2002 Release Notes

I/0 and Networking Cards
Network Drivers
Chapter 5
109
• master file
• init scripts/conf file
• The init script will be hpbtlan and the configuration file will be called
hpbtlanconf.
• The configuration files under /etc/rc.config.d/ will be replaced by hpbtlanconf.
When a cold install is performed, this file will be installed for all btlan driver
claimed cards. If, however, an upgrade is done, you can choose to merge the files using
pre-update scripts. If you do not elect to merge during an upgrade, then the files will,
by default, be saved as .obsolete files which can be later merged manually into the
hpbtlanconf file.
Networking and I/O Card Drivers Pre-Installed
The drivers of all of the following networking, I/O, and mass storage cards are now
pre-installed with (or built into) each of the HP-UX 11i Operating Environments:
updated for
March 2002
• PCI 10/100Base-TX card A3738A will be discontinued starting February 1, 2002
• PCI 4-port 10/100Base-TX card A5506A has been replaced by A5506B
new for
December 2001
• Core 1000Base-T/SCSI card A6794A for HP server rp7410
• PCI Tachyon XL2 Fibre Channel card A6795A
updated for
June 2001
• PCI 1000Base-T (gigabit over copper) card A4929A
• PCI 1000Base-SX (gigabit over fiber) card A4926A
• PCI Combination Dual port 10/100Base-TX and Wide Ultra2 SCSI card A5838A
• PCI 4-port 10/100Base-TX cards A5506A and A5506B
• PCI 10/100Base-TX card A3738A
• PCI core 10/100Base-TX card for workstations and servers
• PCI 10/100Base-TX card A5230A for servers
• PCI 10/100Base-TX card B5509BA for workstations
• PCI Tachyon TL Fibre Channel card A5158A
• PCI FDDI card A3739B
• PCI RAID 4Si controller A5856A
• HSC 10/100Base-TX card J3514A opt #001 2-port for K-Class servers
• HSC 10/100Base-FX (fiber) card J3514A opt #002 2-port for K-Class servers
• HSC 10/100Base-TX card J3515A 1-port for workstations and D-Class servers
• HSC 10/100Base-TX card J3516A opt #001 2-port for workstations and D-Class
servers
• HSC 10/100Base-FX (fiber) card J3516A opt #002 2-port for workstations and
D-class servers
• HSC 10/100Base-TX card J3850A for T-Class server
• HSC 1000Base-SX (gigabit over fiber) cards A4924A, A4925A
• HSC Tachlite Fibre Channel cards A6684A, A6685A
Instructions for configuring built-in (or core) 100Base and 1000Base PCI cards can be
found in Appendix C of the HP-UX 11i Installation and Update Guide.
Combining Pre-HP-UX 11i Configuration Files
In HP-UX 11i, the drivers for PCI and HSC-based Fast Ethernet networking are
consolidated into one driver called btlan, which is pre-installed as part of the kernel.
The configuration files used by these networking drivers in HP-UX 10.20 and