HP-UX 11i June 2004 Release Notes

Workstation/Server Specific Information

Workstations

Chapter 5

Workstations

For the list of supported workstations, see “Supported Systems” on page 74.

Workstation Firmware Requirements

The information that was formerly included in this section can be found in the HP-UX

11i Installation and Update Guide, located at

http://docs.hp.com/hpux/os/11i/index.html#Installing%20and%20Updating.

IMPORTANT HP strongly recommends that you update your system firmware with the latest patches

available at the following Web sites:

http://docs.hp.com/hpux/hw/index.html#System%20Firmware

http://itrc.hp.com

Workstation Graphics Support

Graphics Software Support

HP’s Graphics and Technical Computing bundle includes OpenGL, Starbase, HP PEXlib,

and HP-PHIGS 3D APIs. HP’s workstation graphics software support includes the

run-time and programming environment packages for the 3D graphics APIs named

above, plus additional software for technical computing environments. However, some

functionality (notably accelerated 3D graphics) requires special hardware.

NOTE As of the September 2002 11i release, HP 3D Graphics are no longer supported on

PA-RISC systems older than 2.0. The 3D graphics code is now optimized for PA 2.0

(64-bit capable) processors and will not execute on older PA-RISC microprocessors.

If you have an older PA-RISC workstation and need local 3D graphics support, HP

recommends that you not update to the September 2002 release (or later) of the

Technical Computing (TCOE) or Minimal Computing (MCOE) Operating Environments.

The previous releases of HP-UX 11i contain 3D graphics code that will execute on any

PA-RISC microprocessor.

You can determine the PA version with the System Administration Manager (SAM) by

selecting “Performance Monitors” and then “System Properties.” The PA version appears

on the line labeled “CPU Version.”

Graphics Hardware Support

updated for June

2004

HP-UX 11i v1, as of the June 2004 release, supports the ATI FireGL X1 (A9653A) and

ATI FireGL T2 (AB638A) graphics cards. The ATI FireGL X1 is HP’s new high-end 3D

graphics card, and the ATI FireGL T2 is HP’s new mid-range graphics card. Both are