HP-UX 11i June 2004 Release Notes

HP-UX 11i Version 1 Operating Environment Applications
Selectable Applications
Chapter 6
159
• Installation and recovery of Itanium-based and PA-RISC servers and clients now
occurs automatically by Ignite-UX detecting the hardware type and installing the
correct operating system binaries accordingly.
• Large file impacts, where the file size is greater than 2 GB, are now computed
accurately.
• The call to “vxdisk online,” when configuring VxVM layouts, was removed as it was
unnecessary and could cause problems in client installs in limited circumstances.
• The GUI has been enhanced to allow the _hp_addnl_fs_free_pct parameter to be
modified from the
Additional... button of the Basic tab. This allows you to more finely
tune disk space allocation. See instl_adm (4).
NOTE This is the final release of Ignite-UX that contains support for installation and recovery
of HP-UX 10.20. The Ignite-UX-10-20 bundle and its content will not be provided in
future versions of Ignite-UX. If you want to continue to support HP-UX 10.20 clients, you
must retain an Ignite-UX server that has this or an earlier version installed.
updated for
December 2003
Ignite-UX install environment has been enhanced to include the Gigabit Ethernet
libraries to allow lanadmin to configure these network interfaces during installation.
updated for
September 2003
Ignite-UX has been updated to version B.4.4 to support the following new drivers. Be
sure to configure these new devices before attempting to install HP-UX with Ignite-UX.
• RAID160, ciss
For more information about the RAID160 driver, see “RAID-01 Driver Bundle” on
page 180.
• Fibre Channel, fcd
For more information about the Fibre Channel driver, see “Fibre Channel fcd Driver”
on page 174.
NOTE For documentation about Ignite-UX in previous releases of HP-UX 11i v1, see HP-UX 11i
March 2003 Release Notes, available at http://docs.hp.com.
Documentation
The make_[tape/net]_recovery (1M) and ignite (5) manpages have been updated to
describe that there is no support for filenames with non-printing characters.
The Ignite-UX Administration Guide, B2355-90837, Edition 16 and later, has been
updated to reflect all changes to the product and can be found at
http://www.docs.hp.com/.
Ignite-UX product information and documentation is available at
http://www.software.hp.com/products/IUX/.