HP-UX 11i June 2002 Release Notes

I/0 and Networking Cards
Network Drivers
Chapter 7
141
• hppci100conf (btlan5)
• hpsppci100conf (btlan6)
2. For each of the files found in Step 1, use the command ioscan -kfC lan to find out
if corresponding hardware is present.
Driver Name: File Name
a. btlan -- hpbtlanconf
b. btlan3 -- hpbase100conf
c. btlan4 -- hpgsc100conf
d. btlan5 -- hppci100conf
e. btlan6 -- hpsppci100conf
If hardware is present, check to see if any LAN interface is configured. For example,
the configuration for hpbtlanconf (btlan) would show as follows:
HP_BTLAN_INTERFACE_NAME[0]=lan1
HP_BTLAN_STATION_ADDRESS[0]=0x080009C4686E
HP_BTLAN_SPEED[0]=100HD
3. Create the file hpbtlanconf.merge in the directory /etc/rc.config.d as shown
below:
#####################################################################
(#) hpbtlanconf
# hpbtlanconf: contains config values for HP PCI/HSC 100Base-T
interfaces
#
# HP_BTLAN_INTERFACE_NAME Name of interface (lan0, lan1, ...)
# HP_BTLAN_STATION ADDRESS Station address of interface
# HP_BTLAN_SPEED Speed and duplex mode
#
# The interface name, major number, card instance and ppa may be
# obtained from the lanscan (1m) command.
# The station address and speed are set through the lanadmin command.
#####################################################################
HP_BTLAN_INTERFACE_NAME[0]=
HP_BTLAN_STATION ADDRESS[0]=
HP_BTLAN_SPEED[0]=
#####################################################################
# The HP_BTLAN_INIT_ARGS are reserved by HP. they are NOT user changeable.
#####################################################################
HP_BTLAN_INIT_ARGS="HP_BTLAN_STATION ADDRESS HP_BTLAN_SPEED"
# End of hpbtlanconf configuration file