HP-UX 11i June 2002 Release Notes

I/0 and Networking Cards
Network Drivers
Chapter 7
138
• master file
• init scripts/conf file
• The init script will be hpbtlan and the configuration file will be called
hpbtlanconf.
• The configuration files under /etc/rc.config.d/ will be replaced by hpbtlanconf.
When a cold install is performed, this file will be installed for all btlan driver
claimed cards. If, however, an upgrade is done, you can choose to merge the files
using pre-update scripts. If you do not elect to merge during an upgrade, then the
files will, by default, be saved as .obsolete files which can be later merged
manually into the hpbtlanconf file.
Always-Installed Networking and I/O Card Drivers
The drivers of all of the following networking, I/O, and mass storage cards are now
always installed with (or built into) each of the HP-UX 11i Operating Environments:
Table 7-1 Always-Installed Networking and I/O Card Drivers
Number Description Driver
A3738A
a
PCI 10/100Base-TX card btlan
(btlan6 for 10.20/11.0)
A3739B,
J3626AA
PCI FDDI card fddi4
A4924A,
J1642AA
HSC 1000Base-SX (gigabit over fiber) card gelan
A4925A HSC 1000Base-SX (gigabit over fiber) card gelan
A4926A
b
PCI 1000Base-SX (gigabit over fiber) card gelan
A4929A
b
PCI 1000Base-T (gigabit over copper) card gelan
A5158A
b
PCI Tachyon TL Fibre Channel card fcT1
fcp fcT1_cntl
td
fcparray
A5230A
b
PCI 10/100Base-TX card for servers btlan
(btlan5 for 10.20/11.0)
A5506A
c
PCI 4-port 10/100Base-TX card btlan
A5506B PCI 4-port 10/100Base-TX card btlan
A5838A PCI Combination Dual port 10/100Base-TX
and Wide Ultra2 SCSI card
btlan
(btlan3 for 11.0)
A5856A PCI RAID 4Si controller iop_drv
A6684A HSC Tachlite Fibre Channel card td
fcp
fcparray