HP-UX 11i June 2001 Release Notes

General System Administration and Performance Monitoring

Changes to System Administration Manager (SAM)(updated for June 2001)

Chapter 7 145

determines if any of the resources are critical to HP-UX or SAM, so

that either SAM or HP-UX would fail if the resource were lost. This

menu item properly accounts for resources that have alternates,

backups, or mirrors.

• Added support for DLT device tape densities (DLT_42500_24,

DLT_42500_56, DLT_62500_64, DLT_81633_64).

• In the Tape Devices and Backup and Recovery areas, added

support for the following new tape drives:

— HP C7145/C7146 Autochangers

— HP Suresotre SDKT 220 tape drive

• Added device support for PCI multiplexer needed for Terminals

and Modems area.

• Added device support for HP SureStore Disk Array FC60 and the HP

SureStore Disk Array XP256 (as described in the section, “Disks and

File Systems Area” on page 142).

System Properties (new for June 2001)

• In the System Properites area, SAM recognizes new processors, if

available on the system, and displays information.

Printers and Plotters

• Added support for the Super I/O Parallel Interface. This allows SAM

to recognize this parallel interface and conﬁgure a printer for it.

• Updated the software products supported by SAM that allow the user

to conﬁgure a network printer that has a JetDirect interface card.

• Removed obsolete JetDirect software (/usr/lib/admin/hpnpcfg)

and added support for the new HP JetDirect Printer Installer

(/opt/hpnpl/admin/hppi) software. You can now use SAM to

conﬁgure a network printer using the new HP JetDirect Printer

Installer. SAM still supports the HP JetAdmin Software

(/opt/hpnp/admin/jetadmin).

Terminal and Modems

• Added support for PCI multiplexer cards.

• Added support for modems with hardware ﬂow control.