HP-UX 11i June 2001 Release Notes

I/0 and Networking Cards

Network Drivers (new at 11i original release)

Chapter 5112

• PCI 10/100Base-TX card A5230A for servers

• PCI 10/100Base-TX card B5509BA for workstations

• PCI TachyonTL Fiber Channel card A5158A

• PCI FDDI card A3739B

• PCI RAID controller A5856A

• HSC 10/100Base-TX card J3514A opt #001 2-port for K-Class servers

• HSC 10/100Base-FX (ﬁber) card J3514A opt #002 2-port for K-Class

servers

• HSC 10/100Base-TX card J3515A 1-port for workstations and

D-Class servers

• HSC 10/100Base-TX card J3516A opt #001 2-port for workstations

and D-Class servers

• HSC 10/100Base-FX (ﬁber) card J3516A opt #002 2-port for

workstations and D-class servers

• HSC 10/100Base-TX card J3850A for T-Class server

• HSC 1000Base-SX (gigabit over ﬁber) cards A4924A, A4925A

Instructions for conﬁguring built-in PCI cards can be found in Appendix

C of the HP-UX 11i Installation and Update Guide, part number

5971-2215.

NOTE Tachyon TL is an Agilent manufactured Single Port PCI Fibre Channel

Adapter. It provides 2X PCI support (64-bit 33MHZ) and is a

replacement for the current PCI Tachyon adapters.

On 11i, the new functionality will be primarily OLAR support and boot

support. It allows for a hot swap of the card without rebooting.

Combine Pre-HP-UX 11i Conﬁguration Files

In HP-UX 11i, the drivers for PCI and HSC-based Fast Ethernet

networking are consolidated into one driver called btlan. This new

driver is pre-installed as part of the kernel.