HP-UX 11i Installation and Update Guide, March 2003

Cold Installing HP-UX 11i
Installing HP-UX 11i
Chapter 5 95
• Additional Software: Select networking drivers and other applications
for your system (see “HP-UX 11i Selectable Drivers” on page 72).
IMPORTANT Do not de-select the HPUXBaseAux, HWEnable11i,
OnlineDiag or BUNDLE11i bundles. If in doubt, leave the
selections as default. Other software products may be selectable,
however, we recommend that you do not de-select any products at
this time. For more about Online Diagnostics, see “Diagnostics
Dependencies” on page 75 in Chapter 4.
TIP If you’re installing an Ignite-UX server, be sure to select the entire
Ignite-UX server product, B5725AA, thus installing the new
make_tape_recovery command (see the make_tape_recovery (1M)
manpage) command on your Ignite-UX server.
• At the end of the Guided Installation session, a screen allows you to
review any messages that Ignite-UX encountered. If there are any
errors, resolve them before continuing with the installation.
NOTE Ignore any message stating that /var needs to be larger than
available to hold a dump file. /var typically only needs to be set to
50-100% as large as the current memory to handle dump files.
Step 10. When finished configuring your installation:
•With Guided Installation, select: Finish
•With Advanced Installation, select GO! (at the bottom of any tab). A
confirmation screen lists the disks that will be written to during
installation and a log of any warnings or errors encountered. You
have the chance to
Cancel at this time. If you cancel, you return to
the previous configuration screen.
After you selecting Finish or GO!, the system configures the hard disks
and loads a minimum set of commands and libraries. SD then downloads
all the products and patches from CD1 or DVD1.