HP-UX 11i Installation and Update Guide, March 2003

Known Problems and Troubleshooting
Known Problems Discovered in this Release
Appendix B 157
HP Apache 2.0 Will Not Start on Reboot
By default, HP Apache 2.0 (B9416AA) will not start after rebooting your
system. To fix this problem:
Step 1. Verify that you are using ld and libdld version B.11.32 or higher. To
determine the version, enter the following command:
ld -V
Step 2. If the version number is less than B.11.32, install Patch PHSS_26560.
See “Installing Patches” on page 129 for more information on how to
install patches.
Step 3. As root, manually start HP Apache using the following command:
/opt/hpapache2/bin/apachectl1 start
IMPORTANT TCOE Customers: Due to an ld defect, HP Apache will hang. At the
time of this writing, HP is unable to include a patch for the March 2003
release. For more information please read the Dependencies section in
the HP Apache documentation listed below.
Additional
Documentation
For detailed configuration and installation instructions, see the following
HP Apache documentation in the paths listed below (or at
http://machinename/hp_apache_docs/document after the web server
is started):
HP Apache Admin Guide:
/opt/hpapache2/hp_apache_docs/hpapache.admin.guide
HP Apache Release Notes:
/opt/hpapache/hp_apache_docs/hpapache.release.notes
Cold-Install Warnings from DVD Media
Due to a control script error related to the ordering of HP-UX 11i filesets
on the DVD media, you may receive a series of warning messages in your
swagent.log file.