HP-UX 11i Installation and Update Guide, March 2003

Verifying System Migration
How to Verify Your HP-UX Installation
Chapter 7124
How to Verify Your HP-UX Installation
Verifying HP-UX Installation
To verify that HP-UX 11i was successfully installed, use Software
Distributor’s swlist and swverify commands:
Step 1. To list all products on your system, enter:
/usr/sbin/swlist -a state -l fileset
For example, running swlist on a newly installed partition on an HP
Superdome system could list these product bundles:
CDE-English B.11.11... English CDE Environment
FDDI-00 B.11.11... PCI FDDI;Supported ...
GigEther-00 B.11.11... PCI/HSC/EFF-HSC...
GigEther-01 B.11.11... PCI/HSC/EFF-HSC...
OnlineDiag B.11.11... Online Diagnostics
HPUX11i-OE B.11.11... HP-UX Internet Operating
Environment Component
HPUXBase64 B.11.11... HP-UX 64-bit Base OS
HPUXBaseAux B.11.11... HP-UX Auxilary Software
For a cold-install, compare your listing with the list of software products
provided with 11i, as listed in the tables in the Read Before Installing or
Updating to HP-UX 11i booklet.
For an update, compare your listing with the swlist output obtained
before the update. Software products whose versions have not changed
have not been updated. Use the swverify command to determine
whether those products are compatible with HP-UX 11i.
Step 2. Run swverify to verify that each bundle is intact. For example, to verify
that HP-UX 11i OS is intact, enter:
/usr/sbin/swverify HPUXBase64
Or, to verify all software on your system, enter:
/usr/sbin/swverify \*
The Selection process locates all required filesets for the product. After
the list you should see: