HP-UX 11i Installation and Update Guide, March 2003

Updating to HP-UX 11i
How to Update to HP-UX 11i
Chapter 6 113
Immediately after update-ux is installed, a script copies update-ux to
/usr/sbin/. When update-ux runs for the first time, it will remove the
initial version at the alternate root location.
Step 2: Using update-ux to Update to HP-UX 11i
After you have installed update-ux on the target system (see “Step 1:
Install the update-ux Command (Required Task!)” on page 111) and,
optionally, created an update depot containing all software to be
installed, (see “Optional Step: Create a Network Depot” on page 110),
you can now proceed to update your target system. Use the following
syntax to run update-ux:
update-ux -s source_location [-?] [-a 32|64] [-n|-y] [-i]
[-x option=value] [sw_spec]
NOTE For more information about update-ux syntax, see “update-ux Syntax”
on page 196