HP-UX 11i December 2002 Release Notes

I/0 and Networking Cards
Network Drivers
Chapter 7
162
# HP_BTLAN_STATION_ADDRESS Station address of interface
# HP_BTLAN_SPEED Speed and duplex mode
#
# The interface name, major number, card instance and ppa may be
# obtained from the lanscan (1m) command.
# The station address and speed are set through the lanadmin command.
#####################################################################
HP_BTLAN_INTERFACE_NAME[0]=
HP_BTLAN_STATION_ADDRESS[0]=
HP_BTLAN_SPEED[0]=
#####################################################################
# The HP_BTLAN_INIT_ARGS are reserved by HP. they are NOT user changeable.
#####################################################################
HP_BTLAN_INIT_ARGS="HP_BTLAN_STATION ADDRESS HP_BTLAN_SPEED"
# End of hpbtlanconf configuration file
4. As described in steps a, b, and c below, merge every LAN interface (as shown to be
configured in Step 2) into the file hpbtlanconf in the
/var/adm/sw/save_custom/UNIFIED_MER directory.
a. First, note that a set of three parameters is required for each LAN interface:
• HP_BTLAN_INTERFACE_NAME,
• HP_BTLAN_STATION_ADDRESS and
• HP_BTLAN_SPEED.
b. Second, note that the index value used for the set of three parameters should be
unique for each interface. For example:
HP_BTLAN_INTERFACE_NAME[0]=lan1
HP_BTLAN_STATION_ADDRESS[0]=0x080009C4686E
HP_BTLAN_SPEED[0]=100HD
HP_BTLAN_INTERFACE_NAME[1]=lan2
HP_BTLAN_STATION_ADDRESS[1]=0x080009C4B23C
HP_BTLAN_SPEED[1]=FULL
c. Finally, merge all LAN interfaces by creating a set of three parameters with a
unique index for each:
• Copy the value of the interface name into the parameter
HP_BTLAN_INTERFACE_NAME.
• Copy the value of the station address into the parameter
HP_BTLAN_STATION_ADDRESS.
• If the SPEED parameter exists, and if its value (lowercase or uppercase) is
100FD or 100HD, 10FD or 10HD or auto_on, copy the value into the
HP_BTLAN_SPEED parameter.