HP-UX 11i December 2002 Release Notes

HP-UX 11i Version 1.0 Operating Environment Applications
HP-UX 11i Operating Environment
Chapter 6
109
For the latest information on the HP Apache-based Web Server, including
documentation, Migration Guides, and FAQs, go to the Web at
http://www.hp.com/go/webservers.
HP-UX Runtime Environment for the Java 2 Platform
updated for
March 2002
Both version 1.2 and version 1.3 will be installed. (See the following documentation
section for the location of further information.)
updated for
December 2001
The HP-UX Runtime Environment for the Java 2 (RTE) Platform has been updated to
version 1.3.
updated for
September 2001
The HP-UX Runtime Environment for the Java 2 (RTE) Platform contains the basic
components for executing a Java application on HP servers and workstations with
HP-UX 11i.
Documentation
For further information, please read the release notes in the RTE software. Or, for the
most up-to-date information, go to the Web at:
http://www.hp.com/go/java
HP-UX Support Tools: STM, ODE, & EMS Hardware Monitors
HP-UX Support Tools provide a complete set of tools for verifying, troubleshooting, and
monitoring HP system hardware, including CPUs, memory, interface cards, and mass
storage devices.
Support Tool Manager (STM) is the platform for executing online diagnostics. The
commands to start it are xstm (GUI interface), mstm (menu-driven interface), cstm
(command line interface), or stm (general).
Offline Diagnostic Environment (ODE) is the platform for executing offline
diagnostics. Normally it is run from the Support Plus CD with the system offline.
EMS Hardware Monitors allow you to monitor the operation of a wide variety of
hardware products and be alerted immediately if any failure or other unusual event
occurs. The EMS Hardware Monitors are started automatically with no user
intervention.
NOTE Since the initial release of HP-UX 11i, there have been numerous changes to the Support
Tools, including support for new devices, bug fixes, and enhancements. For the latest
information on these changes, see the “Documentation” section below.
updated for
December 2002
With the December 2002, STM has been updated to version A.35.00. Changes to online
tools (STM and EMS Hardware Monitors) include the following:
• New Fibre Channel Disk Arrays VA7110 and VA7410 are now identified by the STM
ID tool.
• Support for the iSCSI decoder/monitor has been enabled.