HP System Management Homepage Installation Guide, May 2005

13. In the Enable IP restricted logins field, enter YES to enable IP restricted logins or NO to

disable IP restricted logins.

14. In the IP Binding List field, enter the IP address and netmask pairs separated by semicolons.

For exmaple, IPAddress1/Netmask1;IPAddress2/Netmask2.

15. In the Enable IP restricted logins field, enter YES to enable IP restricted logins or NO to

disable IP restricted logins.

16. In the Enter include IP Addresses, or ranges field, enter the IP addresses or range of IP

address to be included.

17. In the Enter exclude IP Addresses, or ranges field, enter the IP addresses or range of IP

address to be excluded.

18. Click Save to save your configuration. Click Cancel to discard your configuration.

19. Click OK to close the HP ProLiant Linux Deployment Utility Utility screen.

20. After pre-configuration is complete, installation can be initiated through the Linux Deployment

Utility as part of the complete ProLiant Support Pack or the single component can be installed

independently.

Installing the System Management Homepage as a

Single Component

You can install the System Management Homepage independently of other components included

in the ProLiant Support Pack.

To install the System Management Homepage as a single component:

1. Select all components except the System Management Homepage component.

2. Right-click all other components and select Do Not Install component. The System

Management Homepage component can also be installed by invoking the following command

from the shell prompt: ./install###.sh –c hpsmh>version<.linux.i???.rpm.

3. This process installs the component with the configurations that are provided through the Linux

Deployment Utility.

For more information regarding using the Linux Deployment Utility, refer to the HP ProLiant Support

Pack and Deployment Utilities User Guide.

Installing the System Management

Homepage without Pre-configuration

You can install the System Management Homepage component without any configurations by

clicking Install. You can configure the System Management Homepage settings at any time by

logging into the System Management Homepage with root privileges.

Installing In-Place on Linux Using Linux Deployment Utility