HP System Management Homepage Installation Guide, May 2005
To install System Management Homepage, enter the following command line:
rpm –ivh hpsmh-2.0.0-linux.i386.rpm
A message appears indicating the System Management Homepage installed successfully with
default configuration values.
Installing System Management Homepage on x86_64
To install System Management Homepage on x86_64 systems, your system must meet the minimum
requirements. For more information regarding minimum requirements, refer to
Chapter2.Installation Requirements. In addition, you must have the
hpsmh-2.0.0.linux-release.x86_64.rpm
Note: Red Hat Enterprise Linux 3 installs the 32-bit compat-db-4.0.14-5.i386.rpm by default
on 64-bit systems. It displays in an rpm querry all command, such as compat-db-4.0.14-5.
Before installing System Management Homepage, ensure that the
compat-db-4.0.14-5.x86_64.rpm is loaded from the distribution CD 3.
To verify 64-bit is loaded on Red Hat Linux 3:
Enter the following command:
rpm --qi --provides compat-db-4.0.14-5 | grep libdb-
If x86_64 bit is installed, libdb-4.0.so()(64bit) is displayed.
To install System Management Homepage, enter the following command line:
rpm –ivh hpsmh-2.0.0-linux-release.x86-64.rpm
A message appears indicating the System Management Homepage installed successfully with
default configuration values.
Configuring System Management Homepage
After the System Management Homepage is installed, you can configure the settings. If you are
migrating from Management HTTP Server, the Management HTTP Server settings are retained.
However, the retained settings are configurable.
To configure System Management Homepage settings:
1. Enter the following command line to start the configuration:
perl /usr/local/hp/hpSMHSetup.pl
34
Installing In-Place on Linux