HP System Management Homepage Installation Guide, May 2005

Chapter7.Installing In-Place on
Linux
This chapter provides steps to install System Management Homepage in-place on Linux IA-32
systems and x86-64 systems.
●
“Installation for Linux on IA-32 and x86_64” (page 33)
❍
“Installing System Management Homepage on Linux IA_32 Systems” (page 33)
❍
“Installing System Management Homepage on x86_64” (page 34)
❍
“Configuring System Management Homepage” (page 34)
The next chapter provides steps to install System Management Homepage in-place on Linux systems
using the Linux Deployment Utility.
●
“Installing System Management Homepage with Pre-configuration” (page 41)
❍
“Pre-configuring the System Management Homepage Component” (page 41)
❍
“Installing the System Management Homepage as a Single Component” (page 43)
●
“Installing the System Management Homepage without Pre-configuration” (page 43)
Installation for Linux on IA-32 and x86_64
The System Management Homepage installation for Linux enables you to silently install the System
Management Homepage on IA-32 and x86_64 systems. After the installation is complete, you can
configure the System Management Homepage settings.
Note:
To install System Management Homepage, you must be logged in as root user.
Installing System Management Homepage on Linux
IA_32 Systems
To install System Management Homepage on IA_32 systems, your system must meet the minimum
requirements. For more information regarding minimum requirements, refer to
Chapter2.Installation Requirements. In addition, you must have the
hpsmh-2.0.0.linux.i386.rpm.
Note: The general 32-bit RPM List is not installed by default.
33