HP System Management Homepage Installation Guide, May 2005

Chapter3.Initial Setup

You can install the System Management Homepage on systems running HP-UX, Linux, and Windows.

Additionally, you can install the System Management Homepage in-place using the Windows

ProLiant Support Pack or the Linux RPM (Red Hat Package Manager), or remotely with optional

preconfiguration using the ProLiant Remote Deployment Utility or the Linux Deployment Utility.

●

For HP-UX Systems

The System Management Homepage is installed or updated using the HP-UX Operating

Environment (OE) media or Applications Release (AR) media. You do not have to configure

any settings to run the product.

For HP-UX, the configuration settings are preserved in the

/opt/hpsmh/conf.common/smhpd.xml file.

●

For Linux Systems

The System Management Homepage is installed by an RPM package without asking you to

configure any settings. After the installation is complete, run the perl script utility to set the

security options used by all of the HP Insight Management Agents on the system. Otherwise

default values are used for these settings.

For Linux systems, the configuration settings are carried over from the

/opt/hp/hpsmh/conf/smhpd.xml file, and the wizard initiates the configuration.

●

For Windows Systems

The configuration settings are carried over from the\hp\hpsmh\conf\smhpd.xml file, and

the wizard initiates the configuration.

Note:

If a Management HTTP Server is currently installed on the machine, the configuration

settings are carried over to that system.

If HP Systems Insight Manager is installed after System Management Homepage is

installed, the System Management Homepage 2048-bit key pair will be replaced

with the HP Systems Insight Manager 1024-bit key pair.