HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on OpenVMS Clients

Installing ISEE OpenVMS Clients in the Shared Server Model

Appendix D

@DISK$USER:[HPSERVICES._COMMON_.SYSTEM]ISEE$SHUTDOWN.COM

NOTE If you do not use the SYS$MANAGER:SYSTARTUP_VMS.COM and/or

SYS$MANAGER:SHUTDWN.COM files, use your appropriate VMS startup and/or

shutdown files to automatically start/stop ISEE upon system reboot or system

shutdown.

Managing the Shared Server Environment with the Command

Line Utility

The Command Line Utility enables nodes to run the ISEE processes and is used to

designate the active node. The first subsection, “Configuring the Active Server”, covers

setting the Shared Server option and adding and activating the active server. The second

subsection, “Configuring Additional Servers”, covers the processes required to enable

fault tolerance.

Configuring the Active Server

1. From the system that you have designated to run the ISEE processes, run the

following command:

$ @ISEE$HPSERVICES:ISEE$INIT.COM

2. Enter 4 to check the configuration check the configuration of this server and press

[Enter].

Figure D-7 ISEE Configuration Utility Menu: Unconfigured Server

See “Verifying Patch Requirements” on page 90 and “Shared Server Model

Prerequisites” on page 92 for more information about required patches and quotas.

3. Read the results of the configuration check, address any outstanding issues, and

press [Enter] to continue.

4. Enter 1 to select the Create the Shared Server Environment option and

press [Enter].

NOTE You may select option 2, in which case you can skip steps 6-9.