HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on OpenVMS Clients
Installing ISEE OpenVMS Clients in the Stand Alone Model
Appendix D
94
@DISK$USER:[HPSERVICES._COMMON_.SYSTEM]ISEE$SHUTDOWN.COM
NOTE If you do not use the SYS$MANAGER:SYSTARTUP_VMS.COM and/or
SYS$MANAGER:SHUTDWN.COM files, use your appropriate VMS startup and/or
shutdown files to automatically start/stop ISEE upon system reboot or system
shutdown.
Managing ISEE on a Stand Alone Server through the Command
Line Utility
The Command Line Utility enables nodes to run the ISEE processes and is used to
designate the active node.
1. From the Stand-Alone OpenVMS server run the following command:
$ @ ISEE$HPSERVICES:ISEE$INIT.COM
The ISEE Configuration Utility will run.
2. Enter 2 to check the configuration of this server and press [Enter]. This step
verifies that patches and quotas are met for this device.
Figure D-4 Stand Alone Configuration Utility Menu: Unconfigured Single Server
3. Read the results of the configuration check, address any outstanding issues, and
press [Enter] to continue. See “Verifying Patch Requirements” on page 90 and
“Stand Alone Server Model Prerequisites” on page 91 for more information about
required patches and quotas.
4. If you want to run the Pre-Configuration utility, enter 3 to access the
Pre-Configuration utility. For more information about the Pre-Configuration utility,
including how to run it, read “Understanding the Pre-configuration Utility” on
page 106. After completing “Running the Pre-configuration Utility” on page 106,
return to step 5 on this page.
If you do not want to use the Pre-Configuration utility, go to the next step.
5. Enter 1 to create the Stand-Alone Server Environment and press [Enter] on your
keyboard.