HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on OpenVMS Clients
Understanding the OpenVMS Installation Options
Appendix D
87
Stand-Alone (non-clustered) OpenVMS Server
In the Stand-Alone model, the ISEE software is installed separately on every OpenVMS
server. Configuration of the ISEE Client information can be done through the
Pre-Configuration Utility (see “Understanding the Pre-configuration Utility” on
page 106) or using the ISEE User Interface. Each Stand-Alone server must be
configured.
Figure D-1 Stand Alone Configuration
To proceed with the ISEE Stand-Alone OpenVMS installation, go to “Verifying Patch
Requirements” on page 90.
The OpenVMS Shared Server Model
The OpenVMS Shared Server model requires the ISEE client software to be installed on
a disk shared by all nodes in the cluster. At least two systems in the cluster are enabled
to run the ISEE processes, but only one system runs it at any given time.
The Shared Server Model requires only one instance of configuration of the ISEE Client
information through the ISEE UI for the entire cluster. It is also more fault tolerant
because additional systems are enabled to run the ISEE processes for the cluster in case
of a fail-over.
Figure D-2 Shared Server Configuration