HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing HP ISEE on Windows Clients

Pre-configuring and Installing Windows Clients

Appendix C

4. Run the following command:

c:\temp\ISEEPlatform\setup.exe /verbose“<path\log_name>”

Example C-2 Running the Installation Command

ISEEPlatform is the default subdirectory created when you unzip the

ISEEPlatform.exe file. If you changed the directory path, you must enter the

alternate directory to run the command in Step 4.

The <path> is the directory to which you will save your log file, and <log_name> is

the name you give your log file. In this example, the file was names install.log

and saved to the c:/temp directory. Make sure there is no space in the command

above between the quotation mark after verbose and the path.

5. Complete “Completing the ISEE Configuration after using the Pre-configuration

Utility” on page 29.