HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on Linux Clients

Pre-Configuring and Installing Linux Clients

Appendix B

4. Execute the following command to complete the configuration file and repackage it

with the tar ball upon completion:

bash repackage.sh

NOTE This command starts an interactive script that allows you to enter configuration

information. Use the information you collected in Table 1-2 on page 18, and read

each option carefully before submitting your information.

5. Read each option carefully, verify that you have collected all of the required

information as listed, and then enter your responses.

This process creates the file ISEEPlatform-custom.tar, which automatically

loads the pre configured data when installed on other ISEE supported Linux devices.

Installing the Client Using the Customized Software Package

1. Place the file ISEEPlatform-custom.tar on the target system for installation.

2. Unpack the .tar file in the installation directory on the Client system:

tar -xf ISEEPlatform-custom.tar

3. Install the software on the Client system by running the command:

bash install.sh

4. Verify that the file ISEEPlatform-custom.tar exists and contains a file named

response. The response file contains the data you preconfigured.

5. Proceed to “Completing the ISEE Configuration after using the Pre-configuration

Utility” on page 29.

NOTE If required by your enterprise, you can create more than one customized HP ISEE

software package on one or more servers to install your HP ISEE Monitored Clients. A

hosting server can also function as Monitored Client.