HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on HP-UX Clients
Pre-Configuring and Installing Multiple HP-UX 11.x Clients
Appendix A
55
NOTE To create multiple customized depots, repeat this step using multiple values for
<depot_directory>. Then proceed with the remaining steps for each
<depot_directory>.
4. Delete the <source_directory>/ISEEPlatform.depot. It is no longer needed.
5. Execute the following command to configure the software:
/usr/sbin/swask -s <depot_directory> ISEE-Chorus
This command starts an interactive script that allows you to enter configuration
information. Use the information you collected in Table 1-2 on page 18, and read
each option carefully before submitting your information.
Verifying the Customized Depot
To verify that a Customized Depot was created correctly, complete the following steps:
1. Run swlist command against the HP ISEE Depot Server. You can run the command
from any HP-UX system.
swlist -d -s <depot_location> ISEEPlatform
Where <depot_location> is the location of the directory depot on the depot server;
for example, swlist -d -s depotServer:/var/depots ISEEPlatform.
The following output is displayed (you may see minor differences in version
numbers):
The following steps are optional.
2. Check for errors in swcopy.log and swagent.log found in /var/adm/sw and
<depot_directory>.
3. Verify that the response file was set correctly. Open the following file:
<depot_directory>/catalog/ISEE-Chorus/pfiles/response
Once you have verified that your Customized Depot is correctly configured, you will use
it to install your HP ISEE Monitored Clients.
Installing the HP-UX Client from the Software Depot
1. Log on to the Client as root.
Table A-1 Verifying the Customized Depot
# ISEEPlatform A.03.50.xxx ISEE Platform
ISEEPlatform.ISEE A.03.50.xxx ISEE
ISEEPlatform.ISEE-Chorus A.A.5.1.350.xxx Motive Chorus
ISEEPlatform.ISEE_EmsListener A.11.07.xx ISEE TCP listener for
EMS events
ISEEPlatform.SysInfo A.01.00.xx ISEE SysInfo