HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Storage Solutions Support Software for ISEE Clients
Configuring Support for Virtual Array Devices
Appendix G
130
Installing the VA Client Software on an ISEE Linux Monitored
Client
1. Download <VAEH-component>.rpm from:
http://software.hp.com to /var/tmp
2. Execute the following command:
rpm -i <VAEH-component>.rpm
Setting the VA New Installation Event
This step is only for or Linux RedHat 7.2 (2.4.2) Clients hosting VA devices. Execute the
following commands to allow the installation event (verification) to be sent to the HP
support center:
cd /opt/hpservices/contrib/vaeh/bin
sh sendInstallEvent.sh
Configuring Command View SDM 1.07 (or higher) security
If CVSDM 1.07 or higher is installed on the array host, follow these instructions to add
the root user as an Administrator in secadmin. For more details refer to the CVSDM
User Guide.
The array security feature is installed automatically when the Command View SDM
software is installed. After installation, security is enabled. The default username is
Administrator and the default password is administrator (the password is case
sensitive). Security can be configured using the Command View SDM Launcher or by the
secadmin command.
1. Run the security administration utility secadmin.
secadmin -host {host_name}
user: Administrator
password: administrator
secadmin prompt appears
2. Add the root user as an Administrator in secadmin
<secadmin on {host name}>
add -user root -group Administrator -host {host name}
password: <root password>
re-enter password: <root password>
NOTE This is the password for the root account
3. Verify that the root has been added to the Administrator group.
<secadmin on {host name}>:list
Username Group Host