HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on Tru64 UNIX Servers
Installing an Individual Tru64 UNIX Client
Appendix E
116
Installing an Individual Tru64 UNIX Client
Complete the installation and configuration steps on each Tru64 UNIX supported. When
installing on a Tru64 UNIX v4.0F cluster the following steps are only required for one
node to install to the entire cluster. When installing on a Tru64 UNIX v5.1A or v5.1B
cluster, the following steps must be performed on every node in the cluster.
Installing the ISEE Client Software
To install HP ISEE on your Tru64 UNIX Client, complete the following steps:
1. Create a directory named ISEEInstall.
Example:
mkdir /usr/ISEEInstall
2. Place the file ISEEPlatform_Tru64.tar in the ISEEInstall directory.
3. Change the directory to the ISEEInstall directory.
Example:
cd /usr/ISEEInstall
4. Unpack the .tar file in the ISEEInstall directory on the Client system:
tar -xf ISEEPlatform_Tru64.tar
5. Install the software on the Client system:
./ISEEinstall.sh
6. Proceed to the single client configuration section in Chapter 2.