HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on OpenVMS Clients
Removing HP ISEE Software
Appendix D
111
Removing HP ISEE Software
If you decide to remove the HP ISEE software from your OpenVMS server, complete the
following steps:
1. Close any ISEE Client Browsers monitoring the target system.
2. Log on to the monitored system.
3. To remove the HP ISEE software from the monitored system run the command:
$ PRODUCT REMOVE ISEE
4. To remove the WCCProxy software from the monitored system run the command:
$ $@WCCPROXY_INSTALL.COM UNINSTALL MASTERISEE
CAUTION Only remove the WCCProxy software if you installed it with the ISEE software. The
uninstall command must be run from the same directory where WCCProxy was
installed. If you installed WCCProxy with a software application other than ISEE,
do not remove WCCProxy.