HP Instant Support Enterprise Edition Client Installation and Upgrade Guide

Installing ISEE on OpenVMS Clients
Installing ISEE OpenVMS Clients with the Multi-server Model
Appendix D
102
@DISK$USER:[HPSERVICES._COMMON_.SYSTEM]ISEE$SHUTDOWN.COM
NOTE If you do not use the SYS$MANAGER:SYSTARTUP_VMS.COM and/or
SYS$MANAGER:SHUTDWN.COM files, use your appropriate VMS startup and/or
shutdown files to automatically start/stop ISEE upon system reboot or system
shutdown.
Managing ISEE in the Multi-Server Environment with the
Command Line Utility
The Command Line Utility activates and enables the nodes running the ISEE processes.
Configuring the First Server in the Multi-Server Environment
Complete the following steps on the first ISEE Monitored Client configured in the
Multi-server OpenVMS model.
1. From the OpenVMS server, run the following command:
$ @ISEE$HPSERVICES:ISEE$INIT.COM
2. Enter 4 to check the configuration check the configuration of this server and press
[Enter].
Figure D-14 ISEE Configuration Utility Menu: Unconfigured Server
See “Verifying Patch Requirements” on page 90 and “Shared Server Model
Prerequisites” on page 92 for more information about required patches and quotas.
3. Read the results of the configuration check, address any outstanding issues, and
press [Enter] to continue.
4. Enter 5 to configure the create the pre-configuration file, and press the [Enter] on
your keyboard. See“Understanding the Pre-configuration Utility” on page 106 for
more information about the pre-configuration utility. After completing the
pre-configuration, complete step 5.
5. Enter 3 to configure the multi-server model (see Figure D-14), and press the
[Enter] on your keyboard.
6. Enter Yes to continue and press [Enter].
7. Press Enter to continue.