HP Fibre Channel Fabric Migration Guide
19
Fabric Migration Guide
Fabric Device Addressing Changes
Private Loop to Fabric Example
Following is a simple example of migrating an HP disk device from a
private loop configuration to a fabric topology.
Figure 0-7 shows a private loop configuration.
Figure 0-7 Private Loop Configuration
The ioscan output for a Private Loop Configuration could be as follows:
Class I H/W Path Driver S/W State H/W Type Description
----------------------------------------------------------------------------
fc 0 0/1/2/0 td CLAIMED INTERFACE HP Tachyon
TL/TS Fibre Channel Mass Storage Adapter
fcp 1 0/1/2/0.8 fcp CLAIMED INTERFACE FCP Protocol
Adapter
ext_bus 3 0/1/2/0.8.0.11.0 fcparray CLAIMED INTERFACE FCP Array
Interface
target 6 0/1/2/0.8.0.11.0.0 tgt CLAIMED DEVICE
disk 3 0/1/2/0.8.0.11.0.0.0 sdisk CLAIMED DEVICE HP OPEN-8
/dev/dsk/c3t0d0 /dev/rdsk/c3t0d0
disk 10 0/1/2/0.8.0.11.0.0.7 sdisk CLAIMED DEVICE HP OPEN-8
/dev/dsk/c3t0d7 /dev/rdsk/c3t0d7
target 7 0/1/2/0.8.0.11.0.1 tgt CLAIMED DEVICE
disk 18 0/1/2/0.8.0.11.0.1.7 sdisk CLAIMED DEVICE HP OPEN-9
/dev/dsk/c3t1d7 /dev/rdsk/c3t1d7
Host
Hub
Disk
Device