HP EISA/PCI Multiplexer Family Cabling, Diagnostics and Troubleshooting Manual

Install Port Modules, Fan Out Cable & Power Supply

Install the Mux Power Supply

Warnin

Always connect the AC/DC adapter to a grounded wall

outlet. The power cord supplied with this product has a

grounded plug. Always use this power cord or a similar one

according to your national code

Warnin

This AC/DC adapter has been designed to operate on all

power systems, including IT power systems. It is

disconnected from the power source by either disconnecting

the power cord from the AC/DC power inlet or by

unplugging the cord from the wall outlet. Use only the HP

AC/DC adapter supplied with this product.

2. Inset the DC output cable plug, with latch (Figure 3-5 insert) of the

plug facing the front of the module, into the port module connector.

Press down firmly until a snapping sound is heard.

3. Connect the cable for the power supply to an AC power outlet.

NOTE Once the power supply is installed, any power source to the left of the

port module is automatically disconnected.

Verify Module LEDs

Each port module contains an online LED and power LED indicator

(Figure 3-5). The online LED is not functional until the driver software is

installed. The power LED is illuminated when power is present in the

module.