HP EISA/PCI Multiplexer Family Cabling, Diagnostics and Troubleshooting Manual

28
Install Port Modules, Fan Out Cable & Power Supply
Mate and Mount Port Modules
2. Attach coupler brackets as shown in Figure 3-2. Use the nickel-plated
screws to secure the coupler brackets to the back of the port module.
Use the black-anodized screws to secure the coupler brackets to the
top and bottom of the port modules.
Figure 3-2 Coupling and wall mounting two port modules
3. Also included with each port module are two wall mounting brackets
and four screws. Attach the mounting brackets to the appropriate
modules and secure them to a surface as shown in Figure 3-2 insert.
NOTE To wall mount a single module, attach one bracket on the top and one
bracket on the bottom at opposite sides of the module.