HP Distributed Print Service Administration Guide

Chapter 5 95
Creating/Configuring Supervisors and Physical Printers
Creating and Configuring Physical Printers
• lp-spool-hp (HP-UX LP spooler)
• lp-spool-bsd (non-HP-UX LP
spooler)
device-name This attribute is required if the value
of the attachment-type attribute is
serial or parallel. This
single-valued attribute specifies the
name of the device file name
associated with the physical printer,
for example, /dev/c1d14_ip. If the
device file name does not include
/dev, then /dev is assumed. That is,
if the device name is not specified as
an absolute pathname, HPDPS adds
/dev to the device name. The device
names for serial or parallel
attachment-type values are system
dependent. Use the HP-UX mksf
command to create the device file if
the device file does not exist. (If you
use SAM to create the physical
printer, the device file will be created
automatically.)
internet-address This attribute is required if the value
of attachment-type attribute is
tcpip, tcpip-bsd, lp-spool-hp, or
lp-spool-bsd. It identifies the IP
address of the physical printer or of
the remote system where the remote
spooler resides.
print-queue-name This attribute is required if the value
of attachment-type is tcpip-bsd,
lp-spool-hp or lp-spool-bsd. It
specifies which remote queue is
associated with a physical printer.
The value identifies the name of the
HP-UX LP spooler destination or
remote spooler queue associated with
the physical printer.