HP Distributed Print Service Administration Guide

144 Chapter6
Configuring Spoolers, Queues, and Logical Printers
Configuring Logical Printers with DCE Security
The logical printer in this configuration does not impose any restrictions
on the use of the physical printer. HPDPS performs job validation at the
physical printer level only.
Using DCE to Restrict Access with Multiple Logical
Printers
This section shows how to use DCE to restrict access to a physical
printer that receives jobs from more than one logical printer through its
associated queue. The example configuration in this section has one
physical printer, but the same principle applies to a configuration with
more than one physical printer. If one or more physical printers that
receive jobs from a queue needs restricted access using DCE, each logical
printer that sends jobs to the queue must be DCE restricted. That is,
authorize-jobs must be set to true and a DCE user group must be
created for each logical printer.
Figure 6-10, “Using DCE to Restrict Access with Multiple Logical
Printers,” shows two logical printers that send jobs to one physical
printer that requires DCE security. One logical printer has default
values provided by an initial value object and the other one does not.