Configuring HP-UX For Peripherals

Appendix B 257
Bus Architectures
Series 700 Bus Architecture
Figure B-1 Model 712 Bus Relationships
Model 725/100
Figure B-2, “Model 725/100 Bus Relationships,” shows a sample layout
for a Model 725/100, and the example that follows it shows its ioscan
-fn output.
The 725 has capability for up to 4 graphics monitors. Core I/O descends
from slot 2 off the system bus, and optionally at slot 5. E/ISA interface
cards configure at slot 4, and additional I/O cards (such as multiple
fast/wide SCSI interfaces and graphics accelerators) can be installed at
slots which show up in ioscan as 10 and 11.
Sample Addresses
Audio capabilities are accessed through hardware address 2/0/8. Access
to the FDDI network would be addressed through 2/0/9. If a Fast/Wide
SCSI interface were plugged into slot 10 and a disk whose SCSI address
is set to 6 were attached to that interface, the disk would be addressed
through 10/0/0.6.