Configuring HP-UX For Peripherals

252 AppendixA
EISA Board Configuration
E/ISA Board Power-Up Messages
Message: Skipping
Cause: Either the slot is empty, or NVM reports the slot is
empty, or the slot has an ISA card but no EEPROM
data, or the slot was skipped because of an already
cited circumstance.
Action: None.
Message: EISA card id eisa_id in slot slot_num had fatal
error
Cause: An EISA card asserted the IOCHK line indicating a
fatal error. An expansion card might do this if there
was a parity error on a memory card. (Not all cards
assert IOCHK.)
Action: Replace the card.
Messages: EISA_WARNING: unable to allocate eeprom_geninfo
EISA_WARNING: unable to allocate
eeprom_slot_info for slot 0
EISA_WARNING: unable to allocate
eeprom_slot_info
EISA WARNING: unable to allocate: func_data
EISA_WARNING: unable to allocate
eeprom_cfg_header
EISA WARNING: unable to allocate eeprom
WARNING: unable to map eeprom registers
EISA WARNING: unable to map eeprom
Cause: These warnings indicate system problems when
attempting to allocate resources necessary for EISA
initialization. If booting from an EISA device, the
system will not boot up. If not booting from an EISA
device, the system will boot up but EISA will not be
initialized.
Action: Call your HP representative.
Message: EISA_WARNING: NVM checksum invalid, clearing
eeprom
Cause: A checksum failed when performed on NVM at
power-up, causing the system to erase the contents of
non-volatile memory. As EISA comes up, it will
complain that NVM data is missing for cards that
identify themselves. eisa_config running from