Configuring HP-UX For Peripherals

250 AppendixA
EISA Board Configuration
E/ISA Board Power-Up Messages
Action: Check CFG file for inaccuracies. Suspect a hardware
problem.
Message: EISA Board ID: eisa_id ignored
Board not present or driver not configured into
kernel
Cause: The ID displayed was obtained from NVM, not the
card. Either an ISAcard is present, but not its driver or
the driver is present, but not the card. (Since ISA cards
do not identify themselves, only the card's driver can
verify its existence.)
Action: Ensure the card in installed and verify that the driver
is configured into the kernel.
Message: EISA Board ID: eisa_id ignored
Driver not configured into kernel
Cause: The system found the EISA card, but not its driver.
Action: Verify that the driver is configured into the kernel.
Message: EISA Board ID: eisa_id ignored, error
initializing board
Cause: A driver accepted this card, but failed to initialize it.
Action: This is probably a defective card.
Message: EISA: eisa_last_attach not called, bad driver
in kernel
Cause: If a driver does return correctly from its attach routine,
this will panic the kernel. Assuming that the drivers
installed are working, this message should never
appear.
Action: If you are using a non-HP card and driver, remove both
the card and driver and try again. If error does not
recur, the non-HP driver is bad. If the error recurs, call
your HP representative.
Messages: EISA WARNING: mapping in system board failed
EISA WARNING: mapping in I/O map entries failed
Causes: System encountered problems either in creating
virtual-to-physical mappings of the EISA system board
registers or in attempting to initialize a system board
resource.