Configuring HP-UX For Peripherals

Chapter 8 205
Configuring Printers and Plotters
Selecting Device Drivers for Your Printer or Plotter
Guidelines for Configuring a Printer to a SCSI
Interface
NOTE There is no SCSI printer driver for Series 700. Also, SAM does not
support SCSI printers.
Table 8-5 SCSI Printer Configuration Requirements
Architecture Interface Card
Interface
and Device
Drivers Default Device Files
Series 800 CIO
27147-60002
a
scsi2
b
lpr3
c
/dev/c#t#d#_lp
d
Series 800
HP-PB
28655A
a
scsi1
e
lpr3
c
(same as above)
a. The following printer models can be configured to the Series 800 SCSI
interface: C2001A, C2106A, C2114A, C2753A, C2754A, C2755A,
C2756A, C2772A, C2773A, C2776A, C2777A
b. Specifying scsi2 causes cio_ca0, sio, pfail, and pa to be
included in the kernel.
c. Specifying lpr3 causes target, sio, pfail, and pa to be included
in the kernel.
d. c#t#d# derives from the hardware path, as shown in ioscan output:
c# is the card instance of the ext_bus class of interface card to which
the printer is attached, t# is the SCSI ID number, d# is the device
number.
e. Specifying scsi1 causes sio, pfail, and pa to be included in the
kernel.