Configuring HP-UX For Peripherals

200 Chapter8
Configuring Printers and Plotters
Selecting Device Drivers for Your Printer or Plotter
Configured to a Serial Port”.
Table 8-1 Serial Printer Configuration Requirements
Architecture Interface Card
Interface and
Device
Drivers Default Device File
Series 700
(internal)
a
asio0
/dev/tty#p#
b
Series 800 CIO
98196A
c
98190A
mux
d
(same as above)
Series 800
HP-PB
40299B
c
J2092A
J2093A J2094A
J2096A
A1703-60022
mux2
e
(same as above)
Series 800
HP-PB
A1703-60003
f
28639-60001
mux4
g
(same as above)
a. The following model printers can be configured to the Series 700
serial interface: 2562C, 2563C, 2566B/C, 2567C, (33449A), 33459A,
(C1645A), C1676A, C2001A, (C2010A), (C2106A), (C2113A),
C2354A, C2356A. (Models in parenthesis are obsolete and are listed
for reference only.)
b. By default, insf creates the standard tty device file shown. For ease
in system administration, HP recommends that you create the
line-printer device file /dev/c#p#_lp, using /usr/sbin/mksf,as
explained in “Creating a Device Special File for a Printer or Plotter
Configured to a Serial Port”. The device naming convention derives
from ioscan output: c# is the card instance for the tty class of
interface card to which the device is attached and p# is the port to
which the printer is attached.
c. The following printer models can be configured to the Series 800
serial interfaces: 2225D, 2227A, 2228A, 2235A/B/C/D, 2276A,
2277A, 2562A/C, 2563A/B/C, 2564B/C, 2565A, (2566A), 2566B/C,
(2567B), 2567C, 2684A, 2686A/D, (2932A), 2934A, (33440A),
33447A, 33449A, 33459A, 33471A, 3630A, 41063A, C1200A,
C1602A, C2001A, C2106A, C2354A. (Obsolete models are shown in
parenthesis and are listed for reference only.)
d. Specifying mux0 causes cio_ca0, sio, pfail, and pa to be
included in the kernel.