Configuring HP-UX For Peripherals

192 Chapter7
Configuring Tape Drives
After Configuring a Tape Drive
After Configuring a Tape Drive
The following manpages, found in the HP-UX Reference give
specifications related to typical tape drive tasks and capabilities:
cpio (1) Copy file archives in and out (cpio is not recommended
for use with 3480 products.)
dd (1) Convert, reblock, translate, and copy a file
ftio (1) Faster tape I/O
mediainit (1) Initialize disk or cartridge tape media; partition DDS
mt (1) Magnetic tape manipulating program
nohup (1) Run a command immune to hangups, logouts, and
quits
pax (1) Portable archive exchange
tar (1) tape file archiver
tcio (1) Command set/80 (CS/80) cartridge tape utility
backup (1M) Backup or archive file system
cstm (1M) Command-line interface to the Support Tool Manager
dump (1M) Incremental file-system dump, local or across network
fbackup (1M) Selectively back up files
frecover (1M) Selectively recover files
install (1M) Install commands
ioscan (1M) Scan I/O system
lssf (1M) List a special file
mk_kernel (1M) Build a bootable HP-UX kernel
mkrs (1M) Construct a recovery system
mksf (1M) Make a special file
restore (1M) Restore file-system incrementally, local or across
network
rmt (1M) Remote magnetic-tape protocol module