Configuring HP-UX For Peripherals

176 Chapter6
Configuring Magneto-Optical Devices
Magneto-Optical Disk Library Configuration Guidelines
Magneto-Optical Disk Library Configuration
Guidelines
This section gives information pertinentto configuring a magneto-optical
disk library. If you are configuring a single magneto-optical disk, refer to
the previous section, “Magneto-Optical Disk Configuration Guidelines”.
Table 6-3, “Magneto-Optical Disk Library Configuration Requirements,”
lists the device drivers required to configure a magneto-optical disk
library to a single-ended SCSI interface for each supported architecture.
Table 6-3 Magneto-Optical Disk Library Configuration Requirements
Architecture
Interface
Card
Interface
and Device
Drivers Default Device Files
Series 700
a
(core I/O only)
(internal)
ssrfc
b
schgr
sdisk
c
/dev/[r]ac/c#t#d#_#[
a|b]
d
Series 800 CIO
e
27147A
scsi2
e
ssrfc
b
autox0
disc3
f
(same as above)
Series 800
HP-PB
a
28655A
scsi1
g
ssrfc
b
autox0
disc3
f
(same as above)
a. The following optical disk libraries are supported on Series 700 (core
single-ended SCSI only) and Series 800 HP-PB buses: C1100A,
(C1150A), (C1160A), (C1170A), C1700C/T, C1704A/C/T,
C1705A/C/T, C1708C/T. (Models shown in parenthesis are obsolete
and are listed for reference only.)
b. Disks in an optical disk library must be accessed through the ssrfc
driver;lthey cannot be accessed directly through the SCSI disk driver
(sdisk or disc3). Also see autochanger(7).