Configuring HP-UX For Peripherals

174 Chapter6
Configuring Magneto-Optical Devices
Magneto-Optical Disk Configuration Guidelines
Magneto-Optical Disk Configuration
Guidelines
This section identifies the device drivers that must be configured into
HP-UX for it to communicate with single magneto-optical disks. If you
are configuring a magneto-optical disk library or adding an optical disk
to an existing magneto-optical disk library, refer to the section,
"Magneto-Optical Disk Library Configuration Guidelines."
Table 6-2, “Magneto-Optical Disk Configuration Requirements,” lists the
device drivers required to configure a magneto-optical disk to
single-ended SCSI interface for each supported architecture.
Table 6-2 Magneto-Optical Disk Configuration Requirements
Architecture
Interface
Card
Interface
and Device
Drivers Default Device File
Series 700
a
(core
I/O only)
(internal)
sdisk
b
/dev/[r]dsk/c#t#d#[
s#]
c
Series 800 CIO
a
27147A
scsi2
d
disc3
e
(same as above)
Series 800
HP-PB
a
28655A
scsi1
f
disc3
e
(same as above)
a. The following optical disks [listed with their respective product ID
strings returned by SCSI Inquiry] can be configured to a Series 700
single-ended SCSI interface, Series 800 CIO or HP-PB single-ended
SCSI interface: C1701A [S6300.650A], C1701C [C1716C], C2550B
[C1716T].
b. Specifying sdisk causes sctl, c700, and wsio drivers to be
included automatically in the kernel.