Configuring HP-UX For Peripherals

144 Chapter5
Configuring Disk Drives, Disk Arrays, and CD-ROM Drives
Selecting Device Drivers for a Disk Device and Interface
floppy disk drives are installed on some Series 700 and E-class (Series
800) computers.
(See also “Considerations for Configuring a Floppy Disk Drive” for
information about using a floppy disk drive with HP-UX.)
Table 5-2 Floppy Disk Drive Configuration Requirements
Architecture
Interface
Card
Interface and
Device
Drivers Default Device File
Model 712 (internal) pcfdc
pcfloppy
/dev/[r]floppy/
c#t#d#
a
Series 700
Single-Ended
SCSI
(internal) sflop (same as above)
Model E
Single-Ended
SCSI
(internal)
disc3
b
(same as above)
a. c#t#d# derives from ioscan output: c# is the card instance for the
ext_bus class of interface card to which the device is attached, t# is
the target (SCSI address) of the disk device on the interface, d# is the
device unit number. See disk (7).
b. Specifying disc3 causes target to be included automatically in the
kernel.