Configuring HP-UX For Peripherals

118 Chapter4
Configuring Terminals and Modems
Additionally Configuring HP-UX for a Terminal
the key to erase, execute an stty command as follows:
stty erase "^?"
Input the ^ and ? characters as separate keystrokes and be sure to
enclose them in quotation marks.
HP 700/60 terminals in VT320 mode uses control-H for backspace.
You can set this up in your .profile or .login file.
Configuring the Wyse 60 Terminal
Configure the Wyse 60 terminal for use as an HP console by executing
the following set of instructions:
Step 1. Install the hardware, as described in the terminal's manual.
Step 2. Configure HP-UX to use the Wyse 60 terminfo file to communicate with
the terminal. To do so, set the TERM variable to wy60 by executing the
following command for Posix or Korn shell:
export TERM=wy60
Your Wyse 60 terminal is now configured for use as an HP system
terminal. Please be aware that the configuration is based solely on the
Wyse 60 default configuration. If further adjustment is required, use the
terminal values provided in Table 4-5, “Wyse 60 Default Configuration
Values.”
Table 4-5 Wyse 60 Default Configuration Values
Display F1 Columns
Lines
Page Length
Attributes
Status Line
Scroll Speed
Cursor
Answerback Mode
Background
Screen Saver
Display Cursor Answerback
Conceal
80
24
1*Lines Char
Standard Jump
Blink Block
Off
Dark
On
On
Off