HP-UX Secure Shell A.05.20.004, A.05.20.005, and A.05.20.006 Release Notes

NOTE: The standard HP-UX patch bundles are cumulative. If you do not find an older bundle,
you can select the latest 11.11 release and use the latest version of the particular patch bundle.
HP recommends that you install the libc, PAM and pthreads patches listed in Table 1-6 with
HP-UX Secure Shell A.05.20.
Table 1-6 libc, PAM and pthreads Patch Requirements
pthreads PatchPAM Patchlibc PatchOperating System
Version
PHCO_26466PHCO_33215PHCO_27740HP-UX 11i v1
No pthreads patch requiredNo PAM patch requiredNo libc patch requiredHP-UX 11i v2
No pthreads patch requiredNo PAM patch requiredNo libc patch requiredHP-UX 11i v3
NOTE: The PHCO_33215 patch fixes a PAM-related issue. Without this patch, pam_acct_mgmt
returned success messages on locked accounts. With this patch, account management fails for
locked accounts (this is the appropriate behavior). In order to log in using ssh, users must unlock
their accounts.
HP-UX Secure Shell Software Availability
HP-UX Secure Shell is available on the following:
• HP Software Depot at: http://www.software.hp.com
• HP-UX Application Release CDs
• HP-UX 11i v1 Operating Environment (OE)
• HP-UX 11i v2 Operating Environment (OE)
• HP-UX 11i v3 Operating Environment (OE)
NOTE: HP-UX Secure Shell is available on the HP-UX Application Release CD, HP-UX 11i v1
OE, HP-UX 11i v2 OE, and HP-UX 11i v3 OE whenever the CD and OEs are available.
Installing HP-UX Secure Shell
You do not need to remove any previous versions of HP-UX Secure Shell before upgrading to
HP-UX Secure Shell A.05.20. However, if you are reverting to an older version of HP-UX Secure
Shell, HP recommends that you remove the new product before reverting to the older version.
To install HP-UX Secure Shell, complete the following steps:
1. Log in as superuser.
2. Insert the software CD into the appropriate drive if installing from the Application Release
CD. If installing from http://software.hp.com, download the depot and use the swinstall
directions provided on the Installation page where you downloaded the software.
3. Run $ swinstall -s <fully-qualified depot source path> at the command
prompt.
4. In the Source Depot Path field, enter the drive mount point and click OK. Change
theSource Host Name, if needed.
5. Select T1471AA (for HP-UX 11i v1 or HP-UX 11i v2) or SecureShell (for HP-UX 11i v3)
from the list of available software, and click Mark for Install on the Actions menu.
6. Click Install on the Actions menu.
7. Click OK in the Install Analysis window when the Status field displays a Ready message.
8. Click Yes. The swinstall command loads the HP-UX Secure Shell files on the system in
approximately 3 to 5 minutes.
10 HP-UX Secure Shell A.05.20