HP-UX Role-Based Access Control B.11.31.05 Release Notes

3. Logon to your system as the root user.
4. Install HP-UX RBAC using the following command:
# swinstall -s /tmp/<RBAC-depotname>.depot AccessControl
The name and location of the HP-UX RBAC depot above is for example only—the actual
name and location may vary.
5. Verify the installation using the swverify AccessControl command. If HP-UX RBAC
installed correctly on the system, the swverify command output includes the following
text:
* Verification succeeded
HP-UX RBAC installs in /usr/bin/ and /usr/sbin/. The swinstall tool displays an error
message if the installation fails. Check /var/opt/adm/sw/swagent.log for information if
the installation failed.
To remove (un-install) HP-UX RBAC B.11.31.05 from your HP-UX 11i v3 systems, you must
complete the following steps:
1. Logon to your system as the root user.
2. Use the following command to remove HP-UX RBAC:
# swremove AccessControl
3. Use the swlist RBACExt command to verify that HP-UX RBAC was removed from the
system. If HP-UX RBAC was removed from the system, the swlist command will report
the following:
# swlist RBACExt
# Initializing...
Contacting target "<hostname>"...
ERROR: Software "RBACExt" was not found on <hostname>.
12 Acquiring and Installing HP-UX RBAC