HP-UX Role-Based Access Control B.11.23.02 Release Notes

HP-UX Role-Based Access Control B.11.23.02
Installing HP-UX RBAC
Chapter10
Removing (un-installing) HP-UX RBAC
Use the following steps to remove (un-install) HP-UX RBAC B.11.23.02 from your HP-UX
11v2 systems:
Step 1. Logon to your system as the root user.
Step 2. Use the following command to remove HP-UX RBAC B.11.23.02:
# swremove AccessControl
Step 3. Use the swlist AccessControl command to verify HP-UX RBAC was removed
from the system. If HP-UX RBAC was removed from the system the swlist
command will report the following:
# swlist AccessControl
# Initializing...
# Contacting target "<hostname>"...
ERROR: Software "AccessControl" was not found on <hostname>.