HP-UX Role-Based Access Control B.11.23.01 Release Notes

HP-UX Role-Based Access Control B.11.23.01
Installing HP-UX RBAC
Chapter 7
Installing HP-UX RBAC
Use the following steps to install HP-UX RBAC B.11.23.01 on your HP-UX 11iv2 systems:
Step 1. Review the “Compatibility Information and Installation Requirements” on page 5.
Step 2. Download HP-UX RBAC by referring to “Acquiring HP-UX RBAC” on page 6.
Step 3. Logon to your system as the root user.
Step 4. Install HP-UX RBAC using the following command:
$ swinstall -s /tmp/<RBAC-depotname>.depot AccessControl
NOTE The name and location of the HP-UX RBAC depot above is for
example only—the actual name and location may vary. You do not
need to reboot the system to install HP-UX RBAC.
Step 5. Verify the installation using the swlist command. If HP-UX RBAC is installed on
the system, the swlist command will report the following:
AccessControl B.11.23.01 HP-UX Role-based Access Control Infrastructure
HP-UX RBAC installs in /usr/bin/ and /usr/sbin/. The swinstall tool displays an error
message if the installation fails. Check /var/opt/adm/sw/swagent.log for information if the
installation failed.
Removing (un-installing) HP-UX RBAC
Use the following steps to remove (un-install) HP-UX RBAC B.11.23.01 from your HP-UX
11v2 systems:
Step 1. Logon to your system as the root user.
Step 2. Use the following command to remove HP-UX RBAC B.11.23.01:
$ swremove AccessControl
Step 3. Use the swlist command to verify HP-UX RBAC was removed from the system.
The swlist command will not report HP-UX RBAC if it was removed from the
system.