HP-UX 11i Security Containment Administrator's Guide for HP-UX 11i v2

1. Be sure your system meets all requirements, as described in “Prerequisites and System
Requirements”.
2. Download the HP-UX 11i Security Containment bundle from Software Depot, as described
in “Installing HP-UX 11i Security Containment”.
3. Log on to your system as the root user.
4. Install HP-UX Standard Mode Security Extensions by using the following command:
# swinstall -x autoreboot=true -s
/tmp/<security_containment_bundle>.depot TrustedMigration PHCO_32144
PHCO_32163 PHCO_32451
5. Go on to “Verifying the HP-UX Standard Mode Security Extensions Installation”.
Verifying the HP-UX Standard Mode Security Extensions Installation
Verify the installation of HP-UX SMSE with the following steps:
1. Run the swverify command to ensure that the bundle installed correctly:
# swverify TrustedMigration
If the installation is successful, many files are displayed and a success message appears after
the verification is complete.
2. Run the swlist command to verify that all parts of HP-UX SMSE are configured correctly
on your system:
# swlist -a state -l fileset TrustedMigration
If the product is configured correctly, each fileset is displayed as configured.
Uninstalling HP-UX 11i Security Containment
This section describes how to remove the HP-UX 11i Security Containment product from your
system.
CAUTION: HP recommends that you leave the SecurityExt bundle on your system. Removing
the entire bundle will remove many patches from your system. Instead, remove only the software
products as described in the following procedure.
NOTE: You must remove HP-UX 11i Security Containment before you remove HP-UX RBAC
or HP-UX SMSE, or you must remove all components at the same time.
To remove HP-UX 11i Security Containment, follow these steps:
1. Log in to your system as the root user.
2. Remove HP-UX 11i Security Containment and all associated software by using the following
command:
# swremove -x autoreboot=true TrustedMigration RBAC Containment
3. Use the swlist command to verify that HP-UX 11i Security Containment and all associated
components were removed from the system.
The swlist command will not report HP-UX 11i Security Containment if it was successfully
removed from the system.
Uninstalling HP-UX RBAC
To remove HP-UX RBAC from your system, follow these steps:
24 Installation